How-to enroll a new fingerprint on your ZKTeco - S922 Biometric Device
Step 01
Press the Menu Button
Step 02
If it does not show “Please verify”, continue to Step
If you have an Admin password set up, it will show “Please verify” –
Start typing the Code/Pin, in this case 999999 as shown.
Step 03
After you entered the Code/Pin, Press OK.
Step 04
If you have a password, select OK with password, and Press OK. If you have a fingerprint as admin, select Fingerprint and press OK to scan.
Step 05
Enter your password and press OK, in this case – 1435.
Step 06
You are now in the MENU section. For this task, we will select User Manage and then Press OK.
Step 07
Select New User and Press OK.
Step 08
Select Select User ID and Press OK.
Step 09
It will then ask for to input User ID, this is the clock code of the
employee on Biosyn. Make sure that you enroll the code exactly as it
is added on Biosyn, then Press OK.
Step 10
Select Fingerprint, then Press OK.
Step 11
It will then ask to Save the enrolment, so remeChoose a finger, then Press OK.mber to Press OK to Save.
Step 12
Ask the employee to scan his/her finger 3 times as shown below, and let them put that
finger on the fingerprint reader once and lift up.
Press the same finger down for a second time and third time
If the finger was not successfully enrolled or already enrolled, it will show a red cross.
Step 13
If enrolled successfully, it will show a green mark as indicated. You can
enrol all 10 fingers if you want, by repeating from step 10.
One Response